For surveillance, networking and access control, how worry-free the result is depends largely on the initial cabling. Once a cable is buried in a wall or closed into a ceiling, changing it means construction work. Here are the choices and site details worth settling first — general craft notes, with no reference to a specific job.
Choosing a cable category
The common options are Cat5e, Cat6 and Cat6a, differing mainly in supported bandwidth and distance: a higher category sustains more speed over the same run. Choose based on current device rates and likely upgrades over the next few years rather than simply buying the highest grade. Whichever you pick, use compliant cable — copper-clad aluminium or thin conductors are the first to fail on long PoE runs.
Installation details that matter later
- Separate low voltage from mains: keep data and power apart, avoid long parallel runs, and use metal conduit where needed to limit interference.
- Leave slack: allow extra length at both ends for re-termination or a cabinet move, and respect the bend radius.
- Labels and records: tag both ends durably and match every ID to the drawings and register; acceptance testing and troubleshooting both depend on it.
- Shielding and grounding: use shielded cable only where interference warrants it, and ground the whole run properly — done badly it makes things worse.
The step not to skip before handover
Test every link for continuity and performance, and file the results. "It all works" said out loud is not a record; with test results on file, an unstable link later can be quickly judged as a cable problem or a device problem. Get the foundation right and whatever runs on top of it is solid.