One of the questions we hear most on cabling jobs is whether each camera needs its own power line. In most network surveillance projects it does not, thanks to Power over Ethernet: a single cable carries both the video stream and the power. Here are the points we explain most often on site — general fundamentals, with no reference to any specific project.
What PoE actually is
PoE delivers DC power alongside data over twisted-pair Ethernet cabling. It is defined in the IEEE 802.3 family, commonly 802.3af, 802.3at and the higher-power 802.3bt. The supplying end, called the PSE, is usually a PoE switch or injector; the powered device, or PD, is the camera, access reader or wireless AP. The two ends negotiate first and only send power once compatibility is confirmed, so an incompatible device is not damaged.
Why surveillance projects favour it
- Half the cabling: no separate mains run to every point, which matters most on poles and in ceilings.
- Centralised power: all cameras draw from a PoE switch in the equipment room, so one UPS can keep the front end running through an outage.
- Easier maintenance: individual ports can be power-cycled, so a frozen camera can be restarted remotely instead of with a site visit.
What to check when designing and installing
Start with the total power budget: add up the draw of every camera (infrared, pan-tilt and heaters raise it considerably) and leave headroom on the switch; then check that each port can supply what the device needs. Cable quality and run length matter too — thin conductors or poor terminations lead to voltage drop or packet loss over distance. For outdoor points, remember surge protection on both the data and power sides.
These are decisions to settle at design time. Get the arithmetic right up front and the system is far easier to operate later.