NEWS / ARTICLE

Home / News / Article

Surge protection and grounding: the overlooked part of a camera system

267 wordsKnow-how

However carefully you choose the devices, if outdoor points lack surge protection and grounding, one storm can take out a whole batch of front-end equipment — and leave faults that are hard to trace. This item is often treated as an afterthought, but it deserves its own line in the design. What follows is general concept; actual practice depends on site conditions and the relevant standards.

How a surge reaches the system

Beyond a direct strike, the more common case is a nearby lightning strike inducing a transient overvoltage on power and signal lines that travels along the cable into equipment. Long overhead runs, outdoor poles and inter-building cabling are especially exposed. The strategy is therefore to divert: give the surge a low-impedance path to ground and bring the whole system as close to one potential as possible.

Three kinds of protection, and equipotential bonding

  • Power protection: fit surge protective devices (SPDs) at the supply inlet and equipment end as needed, and account for a UPS on the room side.
  • Signal and network protection: protect video, control and data lines before they enter equipment; PoE ports need particular attention.
  • Grounding and bonding: ground poles, enclosures, trays and cabinets reliably and bond grounding systems to minimise differences in potential between separate earth points.

Why it belongs in the register

Good grounding is invisible day to day and tends to surface only when something fails. We log SPD models and locations, earth points and test results, and verify the connections are intact during inspections. Quiet, unglamorous basics like this are exactly what decide whether a system weathers a storm.

← Back to news Have a similar need? Talk to us